Filter
Top Products
Table of Contents
viii
2715 Spectrum Analyzer Service Manual
Table 3-18: Power Supply and Serial Bus Connector (J10)
Signal Names and Definitions 3-68............................
Table 3-19: Microprocessor Interface Connector (J550)
Signal Names and Definitions 3-69............................
Table 3-20: Microprocessor Counter Section Connector
Signal Names and Definitions 3-70............................
Table 3-21: Connectors and Signal Names for the Frequency
Counter Section 3-70.......................................
Table 3-22: Pinout for the 24-Pin DIN Connector (J10) Between the
Microprocessor Board, Power Supply Interconnect,
and Serial I/O 3-71.........................................
Table 3-23: Pinout for the Microprocessor Board Test
Connector (J150) 3-71......................................
Table 3-24: Pinout for the 50 Pin Connector (J550) Between
the Microprocessor, Display Storage, and Digital Options
Boards 3-73...............................................
Table 3-25: Real Time Clock Functions 3-75.......................
Table 4-1: Equipment Required 4-2.............................
Table 4-2: Settings for Shape Factor Check 4-5....................
Table 4-3: Settings for the Noise Sidebands Check 4-7..............
Table 4-4: Front Panel Span Accuracy Settings 4-8................
Table 4-5: Maximum Range in 10 dB/Div 4-11.....................
Table 4-6: Resolution Bandwidth Filter Display Dynamic
Range Settings 4-12........................................
Table 4-7: Sensitivity Settings at 110 MHz 4-13.....................
Table 4-8: Sensitivity Settings at 1800 MHz 4-14....................
Table 4-9: Sensitivity Settings at 2.15 GHz 4-15....................
Table 5-1: Test Equipment 5-2..................................
Table 5-2: Power Supply Tolerances 5-7..........................
Table 5-3: Power Supply Tolerances 5-10..........................
Table 5-4: Correction Bit Values 5-39.............................
Table 5-5: Television Channels 5-40..............................
Table 6-1: Relative Susceptibility to Static Discharge Damage 6-2....
Table 6-2: Cal Debug Messages and Meanings 6-9.................
Table 6-3: Servicing Tools for Boards With Surface
Mounted Components 6-15..................................