Filter
Top Products
Maintenance
2715 Spectrum Analyzer Service Manual
6-15
1. Unsolder the component. Use a solder wick to remove access solder.
2. Clean the board with isopropyl alcohol.
3. Solder in the replacement. Surface mounted components are pretinned, and
therefore require little solder.
CAUTION. If you use a soldering iron, use one with a small tip. After applying the
solder paste, touch the corner of the pad with the iron to fasten the component.
Avoid touching the component with the hot soldering iron. Thermal shock causes
hairline cracks that are not visible to the eye.
Table 6- 3: Servicing Tools for Boards With Surface Mounted Components
Description Model Type Tektronix Part No.
Hot Air Repair Terminal Nu-Concepts Systems HART200A N/A
Tempilaq Nu-Concepts Systems N/A
Tem pilaq Thinner Nu-Concepts Systems TLTH N/A
Flux Dispenser Nu-Concepts Systems FD2 N/A
Soldering Iron Hexacon Model SMD10 003 -1401-00
Soldering Iron SMD Tips
Semi-Chisel, 1/16I Hexacon Model Z780X 003-1402-00
Conical, 1/32I Hexacon Model Z783X 003-1403-00
Sharp Conical Hexacon Model Z784X 003-1404-00
Bevel, 1/32I Hexacon Model Z786X 003-1405-00
Chisel, 1/16I Hexacon Model Z787X 003-1406-00
Bevel, 1/16I Hexacon Model Z788X 003-1407-00
Slot 0.062I Hexacon Model S303 003-1408-00
Slot 0.195I Hexacon Model S308 003-1409-00
Slot 0.195I Hexacon Model S314 003-1410-00
Slot 0.195I Hexacon Model S316 003-1411-00
Slot 0.195I Hexacon Model S302 003-1412-00
Stainless Steel, Nonmagnetic
Tweezers
Straight Tip 003-0464-00
Curved Tip 003-0465-00
Silver Solder 251-0514-00