Filter
Top Products
NDA-24298 CHAPTER 4
Page 67
Issue 1
ASYD : Assignment of System Data
SYSTEM
DATA
TYPE
(SYS)
SYSTEM
DATA
INDEX
(INDEX)
0 – 511
DATA
(DATA)
00 – FF
(Hex)
BIT
CORRESPONDING
DATA
SYSTEM DATA CONTENTS
DATA
0/1
BIT
1
7
0b
0
Not used
b
1
Restriction in the number of outside parties who can participate
in the Station Controlled Conference.
0/1 = Not Required/Required
If “0” is set, the outside party who can participate in the Station-
Controlled Conference is as follows:
(a) For Tie Lines, it is possible to call a maximum of seven
lines, as long as the distant PBX returns the answer
signal and release signal.
(b) For C.O. Lines, answer signal and release signal are not
necessary. Only one C.O. LINE can attend the
conference.
If “1” is set, only one outside party can participate in the Station-
Controlled conference.
0b
2
Not used
0b
3
0b
4
Ability to camp-on indication for Attendant Console
0/1 = Normal/Busy LED flashes and Attendant Console hears
ROT if unable to camp-on
b
5
Processing of the following conditions in Automated Attendant
Service:
• When a trunk party has dialed an unused number or a dead
level
• When a trunk party has abandoned dialing a Station Number
• When a station is restricted from connection
• When the calling station does not answer
0/1 = Announcement is sent to the trunk party/Forced release
b
6
Processing after PB Receiver Timeout in Automated Attendant
Service:
0/1 = Forced release/Transfer to ATT (Normally, assign “0.”)
0b
7
Not used
8
Number of Tenants: 1-63 (= 01-3F [HEX.])
9
Number of Attendant Consoles
1IMG: 1~16 (01Hex~10Hex)
4IMG: 1~60 (01Hex~3CHex)
IPX-U (16IMG): 1~60 (01Hex~3CHex)