Filter
Top Products
NDA-24298 CHAPTER 4
Page 285
Issue 1
ASTPN : Assignment of Signal Translation Pattern for NDM
ASTPN: Assignment of Signal Translation Pattern for NDM
1. General
This command assigns the Incoming/Outgoing Selection Translation Pattern Number (PNI/PNO) for incoming
or outgoing trunk route in Fusion Network. The data assigned by this command is written in the Network Data
Memory (NDM) of the Network Control Node (NCN), updating the NDM at each Local Node (LN).
2. Precautions
1. The PNI/PNO is an intermediate parameter to assign additional number (and skip digits) by the AISPN/
AOSPN command.
(a) When IC/OG=I (Incoming) is entered, the additional number is assigned by the AISPN command.
(b) When IC/OG=O (Outgoing) is entered, the additional number and skip digits are assigned by the
AOSPN command.
2. The transmit number translation of the OGC/OGCA method outgoing calls are done by ASTPN/AOSPN
command. Since the additional number and skip digits can be assigned by the AOPRN /AADCN
command for LCR/LCRS method, the ASTPN/AOSPN command may not be required.
3. The system processes ASTPN/AISPN command prior to the numbering plan data. Thus, if the LCR
access code is added to the received numbers by the ASTPN/AISPN command, the system processes the
LCR related command such as ASPAN/AFRSN /AOPRN.
4. The applicable Tenant Number (TN) range is designated by the ASYD command, SYS1, INDEX8. Enter
the tenant number in which this command effects. If data of this command is common for all tenants
(ASYDN command, SYS1, INDEX800, bit4,5=1), assign TN parameter as data “1” for all tenants.