Filter
Top Products
NDA-24298 CHAPTER 4
Page 489
Issue 1
ADIM_T : Assignment of Dial Intercom Data – Telephone Number
ADIM_T : Assignment of Dial Intercom Data – Telephone Number
1. General
This command is used to assign Dial Intercom service related data. The station data of ADIM command can be
assigned by using Telephone Number instead.
2. Precautions
1. Only the Telephone Numbers assigned by the ALGSN command can be used. Telephone Numbers by the
ALGSL command is not available in this command.
2. In case logging in to a LN, only the Telephone Numbers allocated to the stations within the logged-in
node can be used in this command. Also, when logging in to the NCN, the data memory of the whole
nodes in the network can be written.
3. To provide Dial Intercom Service, it is necessary to assign the following data in advance:
ASYD command, SYS1, INDEX 59, b7=1
4. The number of D
term
stations that can be accommodated in a Dial Intercom Group and also the number of
digit for Call Number (Dial Intercom STN) are determined by parameter N (Dial Intercom Digit Number).
5. When N=0 is entered, a maximum of 10 Intercom Station Numbers can be assigned.
When N=1 is entered, a maximum of 64 Intercom Station Numbers can be assigned.
6. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX 8.
7. Enter “My Line” Station Number of D
term
in the ICMSTN (Dial Intercom Station Number) parameter.
8. Compose a Dial Intercom Group with D
term
stations of the same Tenant Number (TN) under the same
Module Group (MG).
9. From 1 to 50 Dial Intercom Groups can be composed on each Module Group (MG) basis.
10. An Intercom member can override another Intercom station in a two-party Intercom connection. This kind
of overriding is referred to as INTERCOM BRIDGE.