NDA-24298 CHAPTER 4
Page 753
Issue 1
ASLU2 : Assignment of Slumber Time Data 2
ASLU2: Assignment of Slumber Time Data 2
1. General
This command assigns the data related to the Slumber Time - Do Not Disturb service feature.
2. Precautions
1. The slumber time period and the forwarded destination are assigned by this command. A maximum of
four (4) different time periods can be assigned as the Slumber Time.
2. The G parameter corresponds to the one assigned by the ASLU1 command. The station numbers
belonging to the slumber group are assigned by the ASLU1 command.
3. Denial of the Slumber Time - Do Not Disturb service feature can be assigned by the following commands:
(a) ARTD command, SLOV = 1 is assigned for trunk route
or
(b) ASFC command SFI = 107, RES = 1 is assigned for the class of the originating station.
4. The AAED command should also be assigned if TFR = 2 (DAT card) is assigned.
5. Time data should be assigned as 24 hours a day (military time).
6. When making multiple time data assignments for a specific Slumber Time Group, the time data assigned
must not be duplicated.
7. If the slumber service is required 24 hours a day, enter the same time data into the both parameters, FROM
HOUR/FROM MINUTE and TO HOUR/TO MINUTE.