Filter
Top Products
NDA-24298 CHAPTER 4
Page 925
Issue 1
ANPDN : Assignment of Numbering Plan Data for Network Data Memory
ANPDN: Assignment of Numbering Plan Data for Network Data Memory
1. General
This command assigns the minimum number of digits needed to determine the service (Telephone Number) that
is required by the first digit received (pre-translation). The data assigned with this command is written in the
Network Data Memory (NDM) of the Network Control Node (NCN), updating the NDM at each Local Node
(LN).
2. Precautions
1. This command is used for the Business Application.
2. The applicable Tenant Number (TN) range is designated by the ASYDN command, SYS 1, INDEX 8.
If the numbering plan is common for all tenants (ASYDN, SYS1, INDEX 800, bit2=1), assign TN
parameter as “1” for all tenants.
3. The system data assignment (ASYDN, SYS 1, INDEX 514, bit1=1) is needed to provide the Network
Data Memory (NDM).
4. For detailed information, see the NEAX2400 IPX Fusion Network System Manual.
3. Data Entry Instructions
TENANT
NUMBER
(TN)
1st DIGIT CODE
(1st DC)
CONNECTION
STATUS INDEX
(CI)
N/H/B
NUMBER OF
NECESSARY
DIGITS
(NND)
MAXIMUM 6
DIGITS
BUSY LAMP FIELD
DISPLAY ACTIVATED
ON
A ATT
(BLF)
0/1
0
NND
The first digits analyzed, prior to the ASPAN command to assign a different
number of digits for this, assign the minimum number of digits in this parame-
ter.
1st DC
The first digit of access code for Telephone
Number. (0-9,*, #)
CI
The status of the 1st DC dialed
N = Normal (Idle)
H = Hooking
B = Busy
BLF
Not used (Fixed to 0)