CHAPTER 4 NDA-24298
Page 760
Issue 1
ACSI : Assignment of Connection Service Index Data
ACSI: Assignment of Connection Service Index Data
1. General
This command assigns the call termination for Direct-in Termination (Day and Night), Night Connection and
Remote Access to System.
2. Precautions
1. The ACFR command assignment is also required to assign the trunk incoming call termination service
feature.
2. When setting the CSI to “6” (Night Connection-Outside) or “7” (Direct-in Termination-Outside) using
this command, the ADC must be set by the ASPD command.
3. Use the ACSA command instead of this command if Direct-in Termination (Day mode only) is required.
4. When the “PFT control by the external key” is required, the following data assignments are needed:
(a) AUNT command, TYPE=2 (PFT)
(b) AEKD command
(c) ANCD command
(d) ACSI command, CSI=4 (Direct-in Termination (Night Mode))
5. The applicable Tenant Number (TN) range is designated by the ASYD command, SYS 1, INDEX 8. Enter
the TN in which this command effects.