Filter
Top Products
NDA-24298 CHAPTER 4
Page 467
Issue 1
ADSL : Assignment of Dterm Soft Key on LCD
5. After system initialization is performed, the soft key cannot be used for a minute.
6. When the soft key data is set on a system basis, SKP = 0 is assigned by this command.
7. The priority order for displaying the data in the function key area (the third line or the lowest line) is as
follows.
8. The LCD display is not changed for a minute, after if the soft key data is assigned to all stations in a
system using this command or the characters for the LCD display are changed using the AFDD command.
9. When the soft key data is programmed for the busy station, the LCD display does not change until the
station becomes idle.
10. The same function data (FKY) can not be assigned to both soft key and function key.
11. The created soft key pattern, which is assigned at SKP=0, is applied to a D
term
Series E by designating the
programmed SKP number in ADKS. As for the key pattern data in SKP=0, ADKS is not necessary. If
SKP=0 is designated in ADKS, default key pattern data (refer to Table 4-12) is applied to the D
term
.
Priority
order
Displayed Data Description
1
Services set to the func-
tion key data
The application service that is set to the function key
2
Services set to the func-
tion key data
Only when the station is idle/originating and the service set to the function key
3
Soft key assigned via
function key
When the soft key data is in the middle of being set via the function key (FKY=122)
4
(a)
Soft key data used on a
station basis
The soft key data assigned via the ADSL (SKP=0) and ADKS command.
(b)
Soft key used on a system
basis
The soft key data is assigned via the ADSL (SKP=0).
(c)
Default soft key data by
ROM data
Default soft key data (a) or (b) data shown above is not programmed.