Filter
Top Products
NDA-24298 CHAPTER 4
Page 809
Issue 1
ACDD_LR : Assignment of Change Digit Code for Dial In Service – Logical Route Number
ACDD_LR: Assignment of Change Digit Code for Dial In Service – Logical
Route Number
1. General
This command is used to assign the Change Digit Code for the ISDN line with DID Addressing. Route number
of the ACDD command can be assigned by using Logical Route.
2. Precautions
1. Prior to this command, logical route data must be allocated by using the ALRTN command.
2. Only when logging in to the NCN (Network Control Node), this command can be used to assign the
logical route data of self-Node and the other Nodes in the Fusion Network. If logging in to a LN (Local
Node), data setting only for the self-node is available. (Error message is indicated if you try to write the
data of other Node.)
3. Data can be entered on a Day/Night basis if specified in the ASYD command, SYS 1, INDEX 75, bit 5=1.
4. This command does not affect if DC = 0 (Sub Address - Addressing) is assigned by the ARTD command.
5. Enter the Logical Route Number of the B-channel route in the parameter “LGRT.”
3. Data Entry Instructions
TRANSFER
SERVICE
(XER)
DAY/
NIGHT
MODE
(D/N)
LOGICAL
ROUTE
NUMBER
(LGRT)
1-899
FUSION
POINT
CODE
(FPC)
1-253
EXTERNAL
ROUTE
NUMBER
(RT)
DIGIT CODE
(DC)
MAX. 7 DIGITS
[0-9, *, #]
CHANGE DIGIT CODE
(CDC)
MAX.24 DIGITS
[0-9, *, #, P]
ADDITIONAL
DIALING
(AD)
D/N
• Day Mode
• Night Mode
DC
Number of digit for this DC
must match the data in DC of
the ARTD command.
LGRT
Enter the Logical Route Number of the
B-channel route.
XFR
Always select “In Service” at XFR parameter
when ISDN DID Addressing is provided.
• In Service = Transfer is valid
• Out of Service = Transfer is invalid
AD
Always select “Out of Service” in AD parameter when ISDN DID Addressing.
• Out of Service = Additional Dialing Service is invalid
• In Service = PBX dial-in Additional Dialing Service (Japan) is valid