Filter
Top Products
CHAPTER 4 NDA-24298
Page 570
Issue 1
ATRK : Assignment of Trunk Data
ATRK: Assignment of Trunk Data
1. General
This command assigns the trunk data as the LENS, Trunk Route number (RT) and Trunk number (TK).
2. Precautions
1. The trunk route (RT) is composed of the trunks (TK). The trunk is categorized into two kinds; the external
trunk and the internal trunk.
(a) The External trunk is an interface to a different node.
(b) The Internal trunk is a common device which is accessed by a station or an external trunk.
2. The attribute data configuring the external trunk route should be assigned by the ARTD command in
advance.
3. The applicable number of external trunk routes (quantity) is designated by the ASYD command, SYS1,
INDEX65.
4. When trunk data has been assigned by this command, the trunk is in the “Make Busy” state. The MBTK
command is used for the Make Busy control.
5. The maximum number of Attendant Console is designated by the ASYD command, SYS1, INDEX9.
6. When an Attendant Console is assigned, the following must also be entered:
(a) RSC: enter “0” normally
(b) SFC: enter “0” normally
(c) TN: tenant number which is handled by the ATT.
Note 1:
When less than 10 tenants, press the Enter key to jump to WRT? field.
Note 2:
The first Tenant Number entered in TN parameter becomes the tenant number of the Attendant Console.
7. When you enter the LENS, you should consider the port appearance of the trunk circuit card, which is
shown in Figure 4-19 through Figure 4-27. The Group number (G) of LENS and the PCM highway
running are illustrated in Figure 4-18.