Filter
Top Products
CHAPTER 4 NDA-24298
Page 768
Issue 1
ANCD_LR : Assignment of Night Connection Data – Logical Route Number
ANCD_LR: Assignment of Night Connection Data – Logical Route Number
1. General
This command is used when the Power Failure Transfer (PFT) circuit card is controlled by the external key.
Route data of the ANCD command can be assigned by logical route number.
2. Precautions
1. Prior to this command, logical route data must be allocated by using the ALRTN command.
2. Only when logging in to the NCN (Network Control Node), this command can be used to assign the
logical route data of self-Node and the other Nodes in the Fusion Network. If logging in to a LN (Local
Node), data setting only for the self-node is available. (Error message is indicated if you try to write the
data of other Node.)
3. When the “PFT control by the external key” is required, the following data assignments are needed:
(a) AUNT command, TYPE = 2 (PFT)
(b) AEKD command
(c) ANCD/ANCD_LR command
(d) ACSI command, CSI = 4 (Direct-in Termination (Night Mode))
3. Data Entry Instructions
FUSION
POINT
CODE
(FPC)
1-253
MODULE
GROUP
NUMBER
(MG)
PORT
NUMBER
OF PFT
CARD
(PORT)
0-11
PFT CARD
NUMBER
(NCU PKG)
0-3
OUTSIDE
ROUTE
NUMBER
(RT)
LOGICAL
ROUTE
NUMBER
(LGRT)
1-899
REMARKS
TRUNK
NUMBER
(TK)
1-255
MG
Enter the data of PFT card assigned by the AUNT
command.
LGRT
Enter the logical route number allocated to the
external route number.
TK
Enter the trunk number connected to the corresponding
circuit number of PFT card.
FPC
Enter the FPC of target Node only when logging
in to the NCN (Network Control Node).
PORT
The port parameter corresponds to the circuit
number of the PFT card.