Filter
Top Products
NDA-24298 CHAPTER 4
Page 453
Issue 1
AKYD_T : Assignment of Key Data for Dterm – Telephone Number
AKYD_T: Assignment of Key Data for D
term
– Telephone Number
1. General
This command assigns the Line Key, Function Key, Intercom Key, and DSS Key data corresponding to each
line/feature button on a D
term
. The station data of AKYD command can be assigned by using Telephone
Number.
2. Precautions
1. Only the Telephone Numbers assigned by the ALGSN command can be used. Telephone Numbers by the
ALGSL command is not available in this command.
2. In case logging in to a LN, only the Telephone Numbers allocated to the stations within the logged-in
node can be used in this command. Also, when logging in to the NCN, the data memory of the whole
nodes in the network is to be written.
3. Prior to this command, Telephone Numbers must be allocated by using the ALGSN command. Only the
Telephone Numbers assigned by the ALGSN command can be used. Telephone Numbers by the ALGSL
command is not available in this command.
4. The D
term
series III (16-button type) and D
term
series E have the default key data. (Refer to Precautions 8.)
If the default data is to be used, assignment in AKYD/AKYD_T is not necessary. The table below shows
the specification pertaining to data assignment for the D
term
.
5. Before assigning the key data for a D
term
using this command, be sure to assign the station data of the
D
term
using the ASDT command (TN, STN, TEC = 12 (D
term
)). The station number assigned by the
ASDT command is referred to as “MY LINE”.
Note
Note:
This “MY LINE” corresponds to the physical port associated with the LENS of a ELC card.
6. By assigning another station line to a feature button using this command, an incoming call terminated to a
station line other than My Line can be answered or can be transferred to elsewhere as in the case of the My
Line. A station line other than My Line is referred to as a “Sub Line.” A “Sub Line” can be assigned not
only to a D
term
but to any conventional telephone. In addition, the station data for My Line and Sub Line
must be assigned by the ASDT command before the key data is assigned. When the Sub Line and the My
Line belong to different tenants, use the ATNR command and clear the “Tenant-to-Tenant Restriction.”
Table 4-14 Data Assignment for the D
term
TYPE OF D
term
LINE/FEATURE BUTTON NUMBER OF BUTTONS
Series III
8-button type KYN = 1-8 8
16-button type KYN = 1-16 16
24-button type KYN = 1-24 24
Series E
8-button type KYN = 1-8 8
16-button type KYN = 1-16 16
32-button type See Figure 4-7 32