Filter
Top Products
NDA-24298 CHAPTER 4
Page 187
Issue 1
ASYDL : Assignment of System Data into Local DM (LDM)
1
805
b
0
(For IPX-UMG system)
Periodic Refresh for office data copy Note 1
0/1 = Execute/Stop
b
1
(For IPX-UMG system)
Partial copy every time office data is assigned
0 = Execute Note 1
1 = Not execute (data copy is executed by CBCD
command
b
2
(For IPX-UMG system)
Information of office data copy condition Note 1
0/1 = -/Output System Message
0
b
3 ~
b
7
Not used
806-831 Not used
832
Fusion Point Code (FPC) of the node connected with
Message Center (MC) in the same MC group
FPC: 1 ~ 253 (01 Hex. ~ FD Hex)
Note: Valid for software version 2 or later.
833
b
0
Interface type for MCI (Message Center Interface)
0/1 = RS-232C interface/LAN interface Note 2
b
1
MCI output text format
0/1 = IMS (ICS) format/IPX format Note 2
b
2
The way to output the call information of LAN
Interface for MCI (when Max. 2 MCs are normally
connected).
0/1 = Dual Output/Single Output
b
3
Output the System Message related to connection
down when the system changeover occurs on LAN
Interface for MCI.
0/1 = Invalid/Valid
b
4 ~
b
7
Not used
Note 1: When office data is assigned by the MAT during IPX-UMG system is in operation, office data (DM/LDM/NDM) copy
is executed from ACT side SP to ST-BY side SP/LP.
Every time office data is assigned by the MAT, the part of the data is copied to ST-BY side SP and each LP when
ASYDL, INDEX805, b1=0. Also office data copy is to be executed when the following operation is performed:
• System Initialization
• Initialization for each Processor
• Execution of the CBCD command
Note 2: When ASYDL SYS1 INDEX833 b0 = 0 (RS-232C interface for MCI) is assigned, either ICS or IPX text format for
MCI output can be selected in b1. When b0 = 1 (LAN interface for MCI) is assigned, b1 data must be fixed to data
“1 = IPX format.”
SYSTEM
DATA
TYPE
(SYS)
SYSTEM
DATA
INDEX
(INDEX)
512 - 1535
DATA
(DATA)
00 - FF
(Hex)
BIT
CORRESPONDING
DATA
SYSTEM DATA CONTENTS
DATA
0/1
BIT