CHAPTER 4 NDA-24298
Page 722
Issue 1
AISD : Assignment of Individual Speed Calling Data
AISD: Assignment of Individual Speed Calling Data
1. General
This command assigns the speed dial number (of the Speed Calling - Station service feature) for a station,
instead of a station user’s registration. This command also allows a maintenance person to monitor present user
settings.
2. Precautions
1. The applicable tenant number (TN) range is designated by the ASYD command, SYS 1, INDEX 8.
2. The station number (STN) specified on this command should be assigned as a master station (MST) by the
AISA command.
3. The data range of the SPD parameter on this command varies depending on the number of memory-blocks
assigned by the AISA command. (One memory-block contains ten memories which store ten different
speed dialing numbers)
3. Data Entry Instructions
STATION
NUMBER
(STN)
SPEED
CALLING
DIGIT CODE
(SPD)
00-99
TENANT
NUMBER
(TN)
STN
Assign the station number designated as a
master station (MST/SLV = 1) by the AISA
command.
TELEPHONE NUMBER (TEL)
MAX. 24 DIGITS
1 200 0 00
1 2 3 4 5
TEL
The dial number to be transmitted by the
system when a station user dial Speed
Calling-Station access code + SPD.
SPD
When assigning the parameter BLOCK = 1 in the AISA
command, assign any data in the range of 00-09 to this
parameter.
When assigning the parameter BLOCK = 2 in the AISA
command, assign any data in the range of 00-19 to this
parameter.