Filter
Top Products
NDA-24298 CHAPTER 4
Page 417
Issue 1
ASCL_T : Assignment of Station Class Data – Telephone Number
ASCL_T : Assignment of Station Class Data – Telephone Number
1. General
This command is used to change the Telephone Equipment Class (TEC), Route Restriction Class (RSC), and
Service Feature Restriction Class (SFC), without changing the station number. The station data of ASCL com-
mand can be assigned by using Telephone Number.
2. Precautions
1. Only the Telephone Numbers assigned by the ALGSN command can be used. Telephone Numbers by the
ALGSL command is not available in this command.
2. In case logging in to a LN, only the Telephone Numbers allocated to the stations within the logged-in
node can be used in this command. Also, when logging in to the NCN, the data memory of the whole
nodes in the network can be written.
3. The station class data (TEC, RSC and SFC) can be changed by ASCL_N command, even if the station to
be changed is in busy status (conversation is in progress). When the station becomes idle, the new class
data becomes effective.
4. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX8.
5. The TEC cannot be changed from a
D
term
Class (TEC=12) to any other Telephone Class, and vice versa.
When it is necessary to change the current TEC to another type of TEC, use the ASDT command to delete
the current station data and assign new station data.
6. The RSC corresponds to the ARSC command, and the SFC corresponds to the ASFC command as well.
7. Update the new class data on the data sheet in the ASDT command.
8. This command is an available software enhancement.