Filter
Top Products
NDA-24298 CHAPTER 4
Page 619
Issue 1
AAEDL : Assignment of Announcement Equipment Data for LDM
3. Data Entry Instructions
Enter EQP as the service feature provided by DAT.
0=Dead Level Number
1=Unused Number
2=Remote Access to PBX
3=May be used for other purposes
4=Outgoing Trunk Busy Announcement
5-6=May be used for other purposes
7=Route Restriction Announcement
8-14=May be used for other purposes
15=Alert Service(for Hotel system)
16=Timed Reminder Set Message (for Business system)/
Service Set-up Message (for Hotel system)
17=Service Set-up Failure Message (for Hotel system)
18=Timed Reminder Cancel Message (for Business system)/
Service Cancel Message (for Hotel Massage)
19=Service Cancel Failure Message (for Hotel system)
20=Room Cut-Off Announcement (for Hotel system)
21=Do Not Disturb Announcement (for Hotel system)
22=Timed Reminder/Wake Up Call Message for Announcement Trunk
23-31=Group Announcement (for Hotel system)
32=Delay Announcement-Attendant (for U.S.A./Canada only)
33=Not Used
34=Automated Attendant (1st Announcement)
35=Automated Attendant (2nd Announcement)
36=Slumber Time-Do Not Disturb (for Slumber Time Group 1)
37=Slumber Time-Do Not Disturb (for Slumber Time Group 2)
38=Slumber Time-Do Not Disturb (for Slumber Time Group 3)
39=Slumber Time-Do Not Disturb (for Slumber Time Group 4)
40=Slumber Time-Do Not Disturb (for Slumber Time Group 5)
41=Slumber Time-Do Not Disturb (for Slumber Time Group 6)
42=Slumber Time-Do Not Disturb (for Slumber Time Group 7)
43-48=Not Used
49-53=Delay Announcement Attendant (1st Announcement)
54-58=Delay Announcement Attendant (2nd Announcement)
59-121=Not Used
122-125=Multiple Announcement
126-127=Not used
EQP
0=Single connection
1=Multiple connection
M
Enter TK data.
Note: This parameter
appears if M=1
is entered.
TK
0=30 seconds, and then disconnects
1=The connection is held until the calling party released
C
TENANT
NUMBER
(TN)
ANNOUNCEMENT
EQUIPMENT
NUMBER
(EQP)0-127
DURATION OF
CONNECTION
(C)
0/1
SENDING
RBT
(R)
0/1
ANSWER
SIGNAL
SENDING
(A)
0/1
MULTIPLE
CONNECTION
(M)
0/1
LOGICAL
ROUTE
NUMBER
(LGRT)
1-899
TRUNK
NUMBER
(TK)
Enter logical route number.
LGRT
0=Send RBT
1=Do not send RBT
R
0=Answer Signal is not sent
1=Answer Signal is sent
A
Note: The EQP for Hotel system is
changeable by the AHSY command,
though the default EQP (service name)
are listed here.
Note
Note
Note
Note
Note
Note
Note
Note