NDA-24298 CHAPTER 4
Page 191
Issue 1
AUNT : Assignment of Unit Data
AUNT: Assignment of Unit Data
1. General
This command assigns the Unit data. It also assigns miscellaneous circuit cards to be mounted in LPM.
2. Precautions
• Prior to assigning the number of the unit data using this command, the ASYD command should be properly
assigned.
• The applicable data range in the Module Group Number (MG) parameter is designated by the ASYD
command, SYS1, INDEX 0.
• Since the PFT is a mechanical action circuit, the PFT operates properly without any data assignment.
However, if the “PFT control by external key” is required, the following data assignments are needed:
(a) AUNT command, TYPE=2 (PFT)
(b) AEKD command
(c) ANCD command
• If the number of the unit’s data deletion is required, you should clear all the station/trunk data within the
unit using the ASDT/ATRK commands.