NDA-24298 CHAPTER 4
Page 57
Issue 1
ATIM : Assignment of Date and Time
ATIM: Assignment of Date and Time
1. General
This command sets the clock information for the system. Clock information is executed when Y is entered in
the WRT? field and the Enter key pressed.
2. Precautions
1. The clock is assigned in military time.
2. Clock information assigned in this command is necessary for the following purposes:
(a) To indicate time for D
term
and ATT (Desk Console/Hotel Console)
(b) To specify the time for changing the route pattern for LCR
(c) To specify the time and date for changing the number development for LCR
(d) To specify the time for outgoing calls or for refusing incoming calls
(e) To specify the start time for the routing diagnosis
(f) To specify a length of time for Traffic Measurement
(g) SMDR
3. The system automatically takes the leap year into account.
3. Data Entry Instructions
Enter the digits with a range from 1 to 31.
Enter 4 digits as the year.
(For example:1999 or 2000)
Enter the digits with a range from 1 to 60.
Enter the digits with a range from 1 to 60.
Enter the digits with a range from 1 to 24.
Enter the digits with a range from 1 to 12.
DAY
MINUTE
SECOND
HOUR
MONTH
YEAR
YEAR MONTH DAY HOUR MINUTE SECOND
DATE TIME