Filter
Top Products
NDA-24298 CHAPTER 4
Page 543
Issue 1
ARTDN : Assignment of Route Class Data for NDM
56 SMDR3
Detailed billing for outgoing in tandem connection.
0 = Required 1 = Not required
Assign this for the
incoming route (ICRT),
if necessary.
57 HDT
Heterogeneous Data Trunk
0 = Not Heterogeneous Data Trunk
1 = Heterogeneous Data Trunk
58 CD
Consecutive Dialing
0 = Out of Service 1 = In Service
59 CCH
Common Channel Handler
0 = CCH is not mounted (normal setting)
1 = CCH is mounted (ISDN or CCIS line )
0000
Always assign data “0”
even ISDN/CCIS.
60 TC/EC 0 0 0 0 Always assign data “0."
61 IRE
Inter-rearranging signal
1=Supervisory
When assigning this
data, always enter zero
(0).
62 SCR
Step Call Restriction for Tie Line Call
0 = Step call is restricted.
1 = Step call is not restricted.
63 LYER1
Layer 1 (For ISDN)
0 = 23 B+D 1= 30 B+D
0= µ law country
1= A law country
64 NET
User/Net Identification (For ISDN)
0 = User Side (normal setting)
1 = Network side
Normally assign data
“0."
65 INT
Interface Specification (For ISDN)
0 = No.7 1 = N-ISDN2 2 = Australia
3 = INS 1500 (NTT) 4 = ITU (CCITT), ETSI
5 = AT&T (#4/#5 ESS) 6 = INS 6 4 (NTT)
7 = NT DMS 100/DMS 250
8=Not used
9 = TTC Q931 a protocol Tie Line (JAPAN)
10 = Q-sig, (ETS 300 172)/IS-11572
11 = Seamless
66 DC
Dialed Number Confirmation (For ISDN)
0 = Sub Addressing
1-15 = DID Addressing Note
Note: Other than 0=
Number of
Main Address
Digits to be
translated.
67 HKS
Hooking Service
0 = Out of Service 1 = In Service
LGRT
1-899
FUNCTION
REMARKS