Filter
Top Products
CHAPTER 4 NDA-24298
Page 654
Issue 1
ARTIN : Assignment of Trunk Application Data for NDM
7 LLCRST Call Restriction by user rate in Low Layer
Capability Information Element
0 = No restriction
1-31 = Call which includes this user rate value is
restricted.
Note
Note:
User rate value is based on
ITU-T Q-931.
8 VCM When assigning this data, always enter zero (0). 0 0 0 0
9 OVRT When assigning this data, always enter zero (0). 0 0 0 0
10 POOL When assigning this data, always enter zero (0). 0 0 0 0
11 DTRT Deletion of ALL 1 alarm signal (DTI Layer 1
alarm)
0 = Not used
1 = Deletion of ALL 1 alarm signal as a Layer 1
alarm
12 TMPRT Temporary Route Information over CCIS
0 = Not used
1 = In CCIS, the route information can be
transferred by the call control messages.
Moreover, the call restriction can be
checked referring to this route information.
13 CODEC When assigning this data, always enter zero (0). 0 0 0 0
14 PASS When assigning this data, always enter zero (0). 0 0 0 0
15 IRL Clear call when DTI alarm is detected
0 = Not used
1 = Clear call when DTI alarm is detected.
Note:
This data should be set when
there is no Dch in the
physical DTI.
16 MTC Assignment of Timer T309 Value.
Restoration timer (TC×MTC) sec.
0-15 = TC×MTC (Restart timer value)
17 TC Timer T309 Counter Value
0 = Not used 1 = 64 msec.
2 = Not used 3 = 2 sec.
4 = 30 sec. 5 = 5 min.
6 = 1 sec. 7 = Not used
18 TS When assigning this data, always enter zero (0). 0 0 0 0
19 CDCSPD When assigning this data, always enter zero (0). 0 0 0 0
CDN
LOGICAL ROUTE NUMBER (1-899)
TRUNK DATA