NDA-24298 CHAPTER 4
Page 295
Issue 1
ACMO : Assignment of Clocked Manual Override
ACMO: Assignment of Clocked Manual Override
1. General
This command assigns the Clocked Manual Override data, which is used for changing routes during a specific
day and specific time period, such as a holiday (Month/Day/Hour/Minute).
2. Precautions
1. The BLOCK parameter is a data index (0-7). A maximum of eight kinds of Clocked Manual Override
Data can be assigned.
2. The PTN parameter corresponds to the TDPTN parameter assigned by the AOPR/ASDC command.
3. The Clocked Manual Override data assigned by ACMO command has priority over the Time Pattern data
assigned by the ATCP command.
4. Time is designated in Military Time. 24 cannot be used as Hour designation.
5. A single set of PTN (Pattern Number) and START/END date and time is to be assigned to a BLOCK
Number. Also the same PTN can be specified to multiple BLOCK Numbers.
6. “PTN = 0” is also used in default setting (in unspecified time period). Thus the assignment “PTN = 0”
means nothing in this command.
3. Data Entry Instructions
Enter a block number for a Clocked Manual Override data
Month/Day
ex.) 09/20 = September 20
BLOCK
BLOCK NUMBER
(BLOCK)
0-7
PATTERN NUMBER
(PTN)
0-7
Pattern number (0-7) assigned by the AOPR/AOPRL/ASDC command.
PTN
Hour/Minute
TIME
DATE
START END
DATE TIME DATE TIME
REMARKS
09 20 17 00 09 21 09 00