CHAPTER 4 NDA-24298
Page 590
Issue 1
ASAT : Assignment of Specific Attendant Number Data
ASAT: Assignment of Specific Attendant Number Data
1. General
This command assigns a specific Attendant Number that allows a station user to access the desired operator.
2. Precautions
1. The applicable Tenant Number (TN) range is designated by the ASYD command, SYS 1, INDEX 8. If
data for this command is common for all tenants (ASYD command, SYS1, INDEX 92, bit3=1), assign TN
parameter as data “1” for all tenants.
2. The specific Attendant Number cannot be a station number or LDN already being used.
3. The maximum number of Attendant Consoles should be assigned by the ASYD command, SYS 1,
INDEX 9.
3. Data Entry Instructions
Enter the tenant number which
affects the special attendant number
TN
TENANT NUMBER
(TN)
ACCESS CODE (ACC)
MAXIMUM 5 DIGITS
ATTENDANT NUMBER
(ATN)
REMARKS
Enter the special attendant number
according to the station numbering plan.
ACC
Enter the ATN which corresponds to the TK parameter assigned by the ATRK command
1 6 0 0 1 1
ATN