NDA-24298 CHAPTER 4
Page 305
Issue 1
AFRSN : Assignment of Flexible Route Selection Data for NDM
AFRSN: Assignment of Flexible Route Selection Data for NDM
1. General
This command assigns the area and/or office code data for the OPR assigned by the AOPRN command. The
data assigned by this command is written in the Network Data Memory (NDM) of the Network Control Node
(NCN), updating the NDM at each Local Node (LN).
2. Precautions
1. The applicable Tenant Number (TN) range is designated by the ASYDN command, SYS1, INDEX8. If
data of this command is common for all tenants (ASYDN command, SYS1, INDEX800, bit4=1), assign
TN parameter as data “1” for all tenants.
2. After an Outgoing Route Selection Pattern Number (OPR) has been assigned in this command, it is
necessary to assign the LCR routing pattern/six (6) digits routing pattern by the AOPRN/ASDCN
command respectively.
3. It should be noted that the access code may or may not be included in the Number Pattern Code (NPC)
depending upon the assignment of AC parameter by the ARTDN command. If zero (0) is assigned, the
access code is not included. If one (1) is assigned, the access code must be included.
4. Assign the dummy route number in the LGRT parameter.
5. When assigning such a number as shown below to parameter “NPC”, enter “T” code to the end digit of
“NPC.”
Example:
When assigning 90 and 900 to NPC:
Number Input Number for NPC OPR
90 90T X
900 900 Y