CHAPTER 4 NDA-24298
Page 652
Issue 1
ARTIN : Assignment of Trunk Application Data for NDM
ARTIN: Assignment of Trunk Application Data for NDM
1. General
This command assigns and deletes trunk application data in Fusion Network. The data assigned by this
command is written in the Network Data Memory (NDM) of the Network Control Node (NCN), updating the
NDM at each Local Node (LN).
2. Precautions
1. This command can be used only when logging in to NCN (Network Control Node).
2. The data assigned by this command is also allocated to the Trunk Application data for physical route
(ARTI). If the Trunk Application data is deleted by using this command, however, the data for physical
route is not to be deleted. Therefore, use the ARTI command to invalidate the Trunk Application Data for
physical route.
3. Data Entry Instructions
See data sheet in Section 4.