Filter
Top Products
NDA-24298 CHAPTER 4
Page 203
Issue 1
ASTD : Assignment of State Translation Data
ASTD: Assignment of State Translation Data
1. General
This command translates the system attributes.
2. Precautions
One STM contains multiple numbers of STS(s), and the combination of the STM”n” and STS”n” has one kind
of (or multiple kinds of) purpose(s) to be designated. The data zero (0) or one (1) assigned in ST designates how
the system works. See Table 4-3 for Assignment of ASTD.
3. Data Assignment Instructions
See Table 4-3.
Table 4-3 List for Assignment of ASTD
STM STS
ST
* = standard settings
0
0
Processing at the time of originating an outgoing
C.O. line call
0
If the calling station is that of RSC = 1, 3, the call
is outgoing via LCR
1* The call is processed by second dial tone system.
Processing for an override from a station into a
connection between COT and another station
0 Override not allowed
1* Override allowed
Passing dial tone
0 Invalid
1* Valid
Processing for warning tone sending at the
moment when ATT has overridden into a
connection between COT and a station (Busy
Verification)
0
Warning tone is sent out to both the ATT and the
station.
1*
Warning tone is sent out to both the station, ATT,
and C.O. side.
Processing for a warning tone sending at the
moment when ATT has overridden into busy
COT (Attendant Override)
0 Warning tone is not sent out the C.O. side.
1* Warning tone is also sent out to the C.O. side.
1
Kind of trunk to be seized for an outgoing C.O.
line call from ATT
0BWT only
1* Either BWT or OGT as the case may be
2 Tandem connection with COT included
0 Restricted
1* Allowed (depending on ARRC)
3 Enable Passing Dial Tone 0*
4 Busy Verification Tone for Att. and Sta. only 0*