NDA-24298 CHAPTER 4
Page 629
Issue 1
ADPCL : Assignment of Determinate Point Code Data for LDM
ADPCL: Assignment of Determinate Point Code Data for LDM
1. General
This command assigns the determinate Point Code (PC) for CCIS and/or the ISDN interface. This data is written
in Local Data Memory (LDM).
Note:
In this command, Determinate Point Code is synonymous with Destination Point Code; the terms are used
interchangeably.
2. Precautions
3. A unique PC must be given to a node in the CCIS network. The OPC (Originating Point Code) is designated
by the ASYD command, SYS1, INDEX180 and 181.
4. The PC is the decimal value from 1 to 16383.
[1-16367 (For CCIS), 1-16383 (For ISDN)]
5. An arbitrary PC may be assigned for the ISDN interface, unless the PC is duplicated in the CCIS network.
6. The PC assigned by this command should correspond to the one assigned by the ACIC1/ACIC2 command.
3. Data Entry Instructions
For CCIS, assign the Logical route number of voice route.
For ISDN, assign Logical route numbers of both B-channel route and
D-channel route.
LOGICAL ROUTE NUMBER
(LGRT) 1-899
DETERMINATE POINT
CODE (PC) 1-16383
REMARKS
For CCIS, enter the PC of destination node.
For ISDN, enter the PC which is not used in CCIS network.
PC
LRGT