Filter
Top Products
NDA-24298 CHAPTER 4
Page 339
Issue 1
AUNE : Assignment of Uniform Numbering
AUNE: Assignment of Uniform Numbering
1. General
This command assigns the data for an inter-network call termination.
2. Precautions
1. This command is available for both ACIS and CCIS. The call termination from CCIS requiring the office
code skip needs this data.
Example:
When the network numberings are as follows, example office data is listed in the table.
Node A 8 - 26 - xxxxx
Node B 8 - 10 - xxxxx
2. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX8. If data
in this command is common for all tenants (ASYD command, SYS1, INDEX93, bit4=1), assign TN
parameter as data “1” for all tenants.
3. Assign the dummy route number in the RT parameter.
4. The data assigned in the NPC should include its access code, and should be different from the NPC
assigned by the AFRS command.
5. The PNL parameter (which is intermediate data to assign the AADC command) appears when ASYD
command is SYS1, INDEX42, bit4=1.
6. Assign the PNL data if additional digit (DC) is required. A maximum of 4 digits of DC is set by the
AADC command. Enter the PNL with a range from 1 to 127. If additional digit is not required, data “0” is
to be set to the PNL parameter.
Node A Node B
ARTD RT = dummy, AC = 1 ARTD RT = dummy, AC = 1
ASPA ACC = 8, SRV = LCR, RT = dummy ASPA ACC = 8, SRV = LCR, RT = dummy
AUNE RT = dummy, NPC = 826, SKIP = 3 AUNE RT = dummy, NPC = 810, SKIP = 3
AMND DC = 826, MND = 8 AMND DC = 810, MND = 8
ARRC
Allow the connection between ICRT
(Voice route in the case of CCIS) and
OGRT (Dummy route).
ARRC
Allow the connection between ICRT
(Voice route in the case of CCIS) and
OGRT (Dummy route).