NDA-24298 CHAPTER 4
Page 405
Issue 1
ATNR : Assignment of Tenant Restriction Class Data
ATNR: Assignment of Tenant Restriction Class Data
1. General
This command assigns the tenant restriction data for each objective situation.
2. Precautions
1. Data can be entered on a Day/Night basis, if specified in ASYD command, SYS1, INDEX75, bit 2=1.
2. The applicable Tenant Number (TN) range is designated by the ASYD command, SYS1, INDEX8.
If data for this command is common for all tenants (ASYD command, SYS1, INDEX 94, bit0=1), assign
TN parameter as data “1” for all tenants.
3. Table 4-9 provides the Tenant Restriction Index (TRI) data. Since the OBJECTIVE SITUATION indi-
cated as “-” may not always be the “Not used” index, do not enter RES=1 for “-” to prevent unexpected
effects.
Table 4-9 TRI
TRI OBJECTIVE SITUATION
0 Station within OGTN calls to a station within TMTN
1 Station within OGTN sets Call Forwarding-All Calls / Busy Line / Don’t Answer to a station within TMTN
2 –
3
Attendant Console within OGTN sets Call Forwarding-All Calls for a station within TMTN (Call Forwarding -
All Calls set/Cancel by ATT)
4
Station within OGTN call to an Attendant Console within TMTN by dialing individual ATT number assigned by
the ASAT command
5 External Key within OGTN changes the Day/Night Mode of TMTN
6 –
7 Incoming call of the trunk within OGTN terminates to a station within TMTN (In the case of MFC signaling only)
8 - 15 –