CHAPTER 4 NDA-24298
Page 276
Issue 1
ANNDL : Assignment of Necessary Digits Data for LDM
ANNDL: Assignment of Necessary Digits Data for LDM
1. General
This command assigns the necessary number of digits for a particular logical trunk route.
2. Precautions
1. This command is needed when the originating call uses both OG mode and signaling as follows:
(a) ASPAL/ASPAN command SRV = OGC/OGCA
(b) ARTD/ARTDN command OSGS = 4/6/7 (Sender Immediate Start/Sender Delay Dial Start/Sender
Wink Start)
2. When the number of the digits for an originating call specified by the NND parameter is dialed, the
following occurs at the same time.
(a) The SND circuit starts to transmit the number information to the external trunk route.
(b) The Originating Register (ORT) circuit is released.
3. The NND parameter assigned by this command determines the number of necessary digits to be received
by the originating register (ORT) circuit.
4. The data entered in NND parameter should include the number of digits of the trunk access code.
3. Data Entry Instructions
I = Incoming (Not used)
O = Outgoing
IC/OG
LOGICAL ROUTE
NUMBER
(LGRT)
1-899
INCOMING/
OUTGOING
CALL
(IC/OG) I/O
NUMBER OF
NECESSARY
DIGITS
(NND) 1-24
REMARKS
Enter desired number of necessary
digits.
NND