Filter
Top Products
NDA-24298 CHAPTER 4
Page 455
Issue 1
AKYD_T : Assignment of Key Data for Dterm – Telephone Number
12. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX8.
13. There is no default key data provided for D
term
(8-button type). The key data for all the line/feature
buttons must be programmed. When assigning the key data of the line/feature button, take the following
precautions:
(a) My Line Key must be assigned in KYN = 1-8, and KYN = 9-16 should be assigned KYI = 0 (Not
used).
(b) The following function keys are basically fixed:
FKY = 13: CONF (Three-Way Calling)
FKY = 18: TRANSFER (Call Transfer-All Calls)
FKY = 20: HOLD (Non-Exclusive Hold/Exclusive Hold)
FKY = 28: ANSWER
FKY = 51: MIC
FKY = 52: SPEAKER
FKY = 57: RECALL
(c) Not used line/feature buttons should be assigned KYI = 0 (Not used).
14. There is no default key data provided for D
term
(24-button type/32-button type). The key data for all of the
line/feature buttons must be programmed. When assigning the key data of the line/feature button, take the
following precautions:
(a) My Line Key must be assigned in KYN = 1-24, and KYN = 25-40 should be assigned KYI = 0 (Not
used).
My Line in KYN = 17-24 cannot be assigned without assigning any Line Key or any Function Key in
KYN = 1-16.
(b) The following function keys are basically fixed.
FKY = 13: CONF (Three-Way Calling)
FKY = 18: TRANSFER (Call Transfer-All Calls)
FKY = 20: HOLD (Non-Exclusive Hold/Exclusive Hold)
FKY = 28: ANSWER
FKY = 51: MIC
FKY = 52: SPEAKER
FKY = 57: RECALL
(c) Not used line/feature buttons should be assigned KYI = 0 (Not used).
15. When using 16 ELCJ (SR 3295, PROG-B or later), the FKY = 49: Speed Calling-One Touch can be
assigned to a maximum of 16 Key Numbers (KYNS).
Note 1:
Speed Calling-One Touch data can be saved by the BOSD command.
Note 2:
Assign the data to the Key Numbers (KYN) in the consecutive order.