CHAPTER 4 NDA-24298
Page 302
Issue 1
AFRSL : Assignment of Flexible Route Selection Data for LDM
AFRSL: Assignment of Flexible Route Selection Data for LDM
1. General
This command assigns the area and/or office code data for the OPR assigned by the AOPRL command. This
data is written in Local Data Memory (LDM).
2. Precautions
1. The applicable Tenant Number (TN) range is designated by the ASYD command, SYS1, INDEX8. If data
of this command is common for all tenants (ASYDL command, SYS1, INDEX800, bit4=1), assign TN
parameter as data “1” for all tenants.
2. After an Outgoing Route Selection Pattern Number (OPR) has been assigned in this command, it is
necessary to assign the LCR routing pattern/six (6) digits routing pattern by the AOPRL/ASDCL
command respectively.
3. The access code may or may not be included in the Number Pattern Code (NPC) depending upon the
assignment of the AC parameter by the ARTD command. If zero (0) is assigned, the access code is not
included. If one (1) is assigned, the access code must be included.
4. Assign the dummy route number in the LGRT parameter.
5. When assigning such a number as shown below to parameter “NPC”, enter “T” code to the end digit of
“NPC.”
Example:
When assigning 90 and 900 to NPC:
Number Input Number for NPC OPR
90 90T X
900 900 Y