Filter
Top Products
CHAPTER 4 NDA-24298
Page 616
Issue 1
AAED : Assignment of Announcement Equipment Data
3. Data Entry Instructions
Enter EQP as the service feature provided by DAT.
0 = Dead Level Number
1 = Unused Number
2 = Remote Access to PBX
3 = May be used for other purposes
4 = Outgoing Trunk Busy Announcement
5-6 = May be used for other purposes
7 = Route Restriction Announcement
8-14 = May be used for other purposes
15 = Alert Service(for Hotel system)
16 = Timed Reminder Set Message (for Business system)/
Service Set-up Message (for Hotel system)
17 = Service Set-up Failure Message (for Hotel system)
18 = Timed Reminder Cancel Message (for Business system)/
Service Cancel Message (for Hotel Massage)
19 = Service Cancel Failure Message (for Hotel system)
20 = Room Cut-Off Announcement (for Hotel system)
21 = Do Not Disturb Announcement (for Hotel system)
22 = Timed Reminder/Wake Up Call Message for Announcement Trunk
23-31 = Group Announcement (for Hotel system)
32 = Delay Announcement-Attendant (for U.S.A./Canada only)
33 = Not Used
34 = Automated Attendant (1st Announcement)
35 = Automated Attendant (2nd Announcement)
36 = Slumber Time-Do Not Disturb (for Slumber Time Group 1)
37 = Slumber Time-Do Not Disturb (for Slumber Time Group 2)
38 = Slumber Time-Do Not Disturb (for Slumber Time Group 3)
39 = Slumber Time-Do Not Disturb (for Slumber Time Group 4)
40 = Slumber Time-Do Not Disturb (for Slumber Time Group 5)
41 = Slumber Time-Do Not Disturb (for Slumber Time Group 6)
42 = Slumber Time-Do Not Disturb (for Slumber Time Group 7)
43-48 = Not Used
49-53 = Delay Announcement Attendant(1st Announcement)
54-58 = Delay Announcement Attendant (2nd Announcement)
59-121 = Not Used
122-125 = Multiple Announcememnt
126-127 = Not used
EQP
0=Single connection
1=Multiple connection
M
TK parameter appears
if M=1 is entered.
TK
0 = 30 seconds, and then disconnects
1 = The connection is held until the calling party released
C
TENANT
NUMBER
(TN)
ANNOUNCEMENT
EQUIPMENT
NUMBER
(EQP)0-127
KIND OF
LANGUAGE
(LANG)
0-15
DURATION OF
CONNECTION
(C)
0/1
SENDING
RBT
(R)
0/1
ANSWER
SIGNAL
SENDING
(A)
0/1
MULTIPLE
CONNECTION
(M)
0/1
ROUTE
NUMBER
(RT)
TRUNK
NUMBER
(TK)
Enter DAT route number assigned
by the ATRK command.
RT
0 = Send RBT
1 = Do not send RBT
R
0 = Answer Signal is not sent
1 = Answer Signal is sent
A
Note: The EQP for Hotel system can
be changed by the AHSY command.
The default EQP (service name)
is listed here.
Note
Note
Note
Note
Note
Note
Note
Note
LANG
0 = Common 1 = Japanese
2 = English 3 = German
4 = French 5 = Spanish
6 = Chinese 7 = Russian
8-15=Spare
Note: LANG is available
for the Hotel appli-
cation.