Filter
Top Products
NDA-24298 CHAPTER 4
Page 537
Issue 1
ARTDN : Assignment of Route Class Data for NDM
6TCL
Trunk Class
Specify the kind of trunk
1 = DDD Line 2= FX
3 = WATS Line
4 = Tie Line/Announcement Trunk
5 = CCSA 6 = Toll Terminal
7 = CAS Line 8= Paging
9 = Code Call Trunk 10 = Dictation Trunk
11 = General Paging Trunk
12 = Radio Paging Trunk 13 - 31 = Not used
7L/T
Line/Trunk Identification
0 = Not used (Line) 1 = Trunk
11111Always assign data “1.”
8RLP
Trunk Release Pattern
0 = Calling Party Release (Outgoing only)
1=Not used
2 = First Party Release (either station or trunk side)
3=Not used
Normally assign data
“2.”
9TQ
Outgoing Trunk Queuing
0 = Out of Service 1 = In Service
10 SMDR
Detailed Billing Information
0 = SMDR Out of Service
1 = SMDR In Service (ORT required for receiving all dialed
digits
11TD Toll Denial Battery Reversal 00000Always assign data “0.”
12 DR
Distinctive Ringing Pattern
This parameter designates whether distinctive ringing will
be provided for an incoming call.
0 = Distinctive Ringing is not required
(ASYD, SYS 3, Index 3, Bit 0=0)
1 = Distinctive Ringing is required
(ASYD, SYS 3, Index 3, Bit 0=1)
13 AC
Flexible Routing Pattern Designation
When outgoing route selection pattern number is to be
determined by the AFRS command, “1” is to be assigned if
the Access Code is included in the Number Pattern Code
(NPC).
0 = When flexible routing is executed, numbers are translated
excluding the Access Code
1 = When flexible routing is executed, numbers are translated
including the Access Code
This data is valid for
dummy routes. Assign
data “1” for the dummy
route.
14 TNT
Tenant Number Check
0 = Tenant number check is not required in trunk selection.
Always assign data “0.”
LGRT
1-899
FUNCTION
REMARKS