NDA-24298 CHAPTER 4
Page 845
Issue 1
AEVT : Assignment of Virtual Tie Line Data for Event Based CCIS
AEVT: Assignment of Virtual Tie Line Data for Event Based CCIS
1. General
This command assigns Virtual Tie Line data for Event Based CCIS.
2. Precautions
1. When the parameter Verification of Connection (VRY) is assigned as “1,” if the Calling party number is
not the same as the number assigned in the parameter CALLED, connection is not established.
2. The parameter FUNC = 2 is necessary to activate Event Based CCIS using the private ISDN line.
3. Data Entry Instructions
TYPE
1=Separate Channel System
2=Separate Channel System (for Call-By-Call)
3=Common Channel System
4=Common Channel System (When "NPI" and
"TON" are assigned by the ACBC command)
DESTINATION
E-CCIS trunk
identification number.
OPR Note
Assign Outgoing Route
Selection pattern number.
RA Note
Assign the order of
route advancing.
CALLED
CALLED NUMBER
(CALLED)
1-24
CCIS_RT
1-255
CCIS_TK
1-255
VRY
0/1
OPR
1-4000
RA
0-7
DID number for
outgoing call
CALLING
DID number for incoming
call from an E-CCIS
CCIS_RT/CCIS_TK
Assign CCIS signal route and
trunk number.
VRY
Verification of connection
0=Not required
1=Required
Note:
♦ When FUNC=1 and TYPE=1/2 are assigned
"OPR" and "RA" parameters appear for TYPE=2.
FUNCTION
ROUTE
NUMBER
(RT)
1-255
TRUNK
NUMBER
(TK)
1-255
DESTINATION
NUMBER
(DESTINATION)
6 DIGITS
CALLING NUMBER
(CALLING)
1-24
TYPE
1-4
1