CHAPTER 4 NDA-24298
Page 646
Issue 1
ARTI : Assignment of Trunk Application Data
ARTI: Assignment of Trunk Application Data
1. General
This command assigns Trunk Application Data.
2. Precautions
1. The ARTD command should be assigned for the external trunk route.
2. The applicable number of the external trunk route is designated by the ASYD command, SYS1,
INDEX65.
3. Data Entry Instructions
See data sheet in Section 4.
4. Data Sheet
CDN
ROUTE NUMBER
TRUNK DATA
1RST
Assignment of Restart
0 = Restart Send per Individual Channel
1 = Not used 2 = Not used
3 = Restart not Send
2HMT When assigning this data, always enter zero (0). 0000
3 TRCRST
Call Restriction by Information transfer rate in Bearer
Capability Information Element
0 = No restriction
1 = Data call restriction (Unrestricted digital,
Restricted digital and Video data calls are
restricted.)
2 = Speech call restriction (Speech, 3.1 kHz audio and
7 kHz audio calls are restricted.)
3-15= Not used
4TRSRST
Call Restriction by Information transfer rate in Bearer
Capability Information Element
0 = No restriction
1 = 384 Kbps (H0) call is restricted
2 = 1536 Kbps (H11)/1920 Kbps (H12) call is
restricted.
3 = 384 Kbps and 1536 (H11)/1920 Kbps (H12) calls
are restricted.
4-15= Not used
5 T309LNK
Assignment of Timer T309 for Data Link Failure
0 = Layer 2 Alarm with T309 for Data Link Failure
1 = Layer 2 Alarm [Temporary] with T309 is enabled
2 = Layer 2 Alarm [Permanent] with T309 is enabled
3= Not used