Filter
Top Products
CHAPTER 4 NDA-24298
Page 476
Issue 1
ADRTL : Assignment of Dterm Display Route Data for LDM
ADRTL: Assignment of D
term
Display Route Data for LDM
1. General
This command changes the display of trunk class information on the D
term
instead of the Trunk Class (TCL)
designation of the ARTD command.
2. Precautions
1. The data assigned in this command affects the stand alone-node and Local Node (LN).
2. When this data is assigned to Local Data Memory (LDM) in the Fusion Network, if Network Data
Memory (NDM) has Display Route Data designated by the ADRTN commands, NDM data overrides
LDM data.
3. The data assigned by this command is not available for ISDN stations and PS.
4. When a call terminated from the trunk COC number has been assigned by the ACOC command, the
following is displayed on the D
term
as to “TYPE” parameter;
• TYPE = 1 (4 characters) is entered, both COC number assigned by the ACOC command and 4-
character trunk class assigned at “DISP” parameter is displayed.
• TYPE = 2 (8 characters) is entered, only the 8-character trunk class assigned at “DISP” parameter is
displayed.
3. Data Entry Instructions
The maximum number of characters
1 = 4 (4 bytes ASCII characters)
2 = 8 (8 bytes ASCII characters)
TYPE
Assign Physical Route number at the non-Fusion
node.
RT
Route
Number
(RT)
Character
Display Type
(TYPE)
1, 2
Display for Trunk Class on D
term
(DISP)
REMARKS
The characters displayed on the D
term
.
DISP
Note: For Fusion node, assign Logical Route number
using the ADRTN command.