Filter
Top Products
NDA-24298 CHAPTER 4
Page 361
Issue 1
ARSC : Assignment of Route Restriction Class
ARSC: Assignment of Route Restriction Class
1. General
This command assigns route restriction information according to the Route Restriction Class (RSC) of the
station and the Route Number (RT).
2. Precautions
1. Data can be entered on a Day/Night basis, if specified in ASYD command, SYS1, INDEX75, bit 0=1.
2. The applicable Tenant Number (TN) range is designated by the ASYD command, SYS1, INDEX8. If data
of this command is common for all tenants (ASYD command, SYS1, INDEX92, bit4=1), assign TN
parameter as data “1” for all tenants.
3. The displayed Route Restriction Class (RSC) corresponds to the one assigned by the ASDT command.
4. The details of each RRI are as follows:
5. The restriction data (RES) is entered in the text box where RSC and RRI cross.
6. When RES=2 is assigned in RRI=3, ATDP/AARP (Toll Restriction 3/6 digits) should be assigned to
specify the connection allowed area.
7. The parameter RES = “2” (Toll Restriction is allowed) is valid only when the parameter RRI = “3” (OG
Restriction Directly) is assigned.
RRI Descriptions
RRI-0 Trunk incoming connection with an Attendant Console (or a station) assistance.
RRI-1 Trunk incoming connection without assistance.
RRI-2 Trunk outgoing connection with an Attendant Console (or a station) assistance.
RRI-3
Trunk outgoing connection without assistance.
Note: For the dummy route, assign the data to RRI3 only.