Filter
Top Products
Operating Examples
AWG2021 User Manual
2 Ć73
Using the Auto Load process, it is possible to automatically load files from a
designated device into the instrument’s internal memory when the power to the
instrument is turned on. You can do this with the following procedure:
1. Select Auto Load from the bottom menu.
2. Select from NVRam from the side menu.
3. Power the instrument off, then on again.
Check to make sure that the designated files were loaded from the NVRAM
to the internal memory when the power to the instrument was turned on.
This completes the Example 4.
Also, note that files are loaded/saved in the same manner when the Device is set
to Disk. For a floppy disk, hierarchical file structures can be created using
directories. See the UTILITY menu Disk item in Section 3, Reference, for
directory creation instructions.
NOTE. You must format new floppy disks. See the UTILITY menu Disk item in
Section 3, Reference, for formatting instructions.
Auto Load