Filter
Top Products
Operating Examples
AWG2021 User Manual
2 Ć45
6. Select Edit from the side menu.
The SAMPLE–2 waveform file will appear on the screen.
You will now set the range for waveform creation. The arbitrary waveform will
be created within this range using the Point Draw function.
7. Press the CURSOR button on the front panel. This will activate the vertical
cursor bar in the left-hand side of the screen.
8. Press “2”, “5”, “0”, and ENTER to set the point value of the left cursor to
250.
9. Press the CURSOR button on the front panel again to activate the vertical
cursor bar in the right-hand side of the screen.
10. Press “7”, “5”, “0”, and ENTER to set the point value of the right cursor to
750.
Figure 2 Ć32: Setting the Edit Range
You may now create the arbitrary waveform within the range designated by these
two vertical bar cursors, using the Point Draw function.
11. Select Operation from the bottom menu.