Filter
Top Products
EDIT Menu
3 Ć42
AWG2021 User Manual
Invert... Invert function
Clip... Clip function
Marker... Setting a marker
Insert Other Waveform Inserting other waveforms
Single Waveform Math... Single waveform calculations
Dual Waveform Math.... Calculations with other waveform data
Region Shift... Specified region shift
When editing two or more waveforms simultaneously, three more items are
added to the side menu (and the size of the menu increases to four pages).
Multiple Copy... Multiple copy
Convolute... Convolution calculations
Compare... Comparing waveforms
Items with “...” have further low-level side menus, called sub-menus.
Setting Editing Areas. The editing operations available under Operation are all
performed in the editing area located between the left and right vertical bar
cursors. Before beginning the editing process, you should define the editing area
using the following procedure.
1. Select Operation from the bottom menu.
2. Press the CURSOR button on the front panel to make the left vertical cursor
active (solid line).
3. Using the numeric keys or the general purpose knob, move the left cursor to
the starting point for the editing operation you wish to perform.
4. Press the CURSOR button on the front panel again to make the right vertical
cursor active (solid line).
5. Using the numeric keys or the general purpose knob, move the right cursor
to the endpoint for the editing operation you wish to perform.