Filter
Top Products
Operating Examples
2 Ć78
AWG2021 User Manual
Example 6: Using the Waveform Function Generator
The instrument is equipped with a waveform function generator for generating
simple waveform functions. Pressing the F.G button on the front panel will
change the mode to function generator (FG) mode and enable you to set various
waveform parameters.
In Example 6, you will select a sine wave for CH1. Then you will set the
parameters and output the waveform.
1. Press the front panel F.G (Function Generator) button. The FG mode menu
is displayed.
As described below, you will define a 200 kHz, 5 V amplitude, 0 V offset sine
wave on CH1.
1. Select Sine from the bottom menu.
Figure 2 -66 shows a sine wave displayed within the CH1 frame on the
screen.
Figure 2 Ć66: Screen When Sine Set for CH1
Set the frequency to 1 MHz.
CH1 Waveform Settings