Filter
Top Products
Function Waveform Generator Mode
AWG2021 User Manual
3 Ć301
The sync signal is a 1.5 V signal into 50 W with a pulse width of 100 ns. These
signals are output from the front panel CH1 SYNC connector and the rear panel
CH2 SYNC OUT connector (for Option 02).
The marker signal is generated at the start point for the waveform data. It is a
2.5 V signal into 50 W, whose pulse width varies with the frequency of the
output signal (see Table 3-24, earlier in this section). These signals are output
from the front panel CH1 MARKER1 output connector and the rear panel CH1
MARKER2 OUT connector. When Option 02, the CH2 option, is installed, the
marker signals are output from the rear panel CH2 MARKER1 OUT and CH2
MARKER2 OUT connectors.
Marker Signal