Filter
Top Products
MODE Menu
AWG2021 User Manual
3 Ć235
Impedance
STOP
The Polarity, Level and Impedance items are used to set the gate conditions for
the external gate signal.
Figure 3 -163 shows the output waveform for an external gate signal.
External Gate Signal
Output Signal
Figure 3 Ć163: Output Waveform for External Gate Signal in Gated Mode
Use Burst mode to output the specified waveform or sequence for the burst
count when a trigger is generated, then stop output. The trigger signal depends
on the trigger source. It can be generated from the external trigger signal applied
to the TRIGGER INPUT connector or by pressing the front panel MANUAL
button.
During waveform output, if the MANUAL button is pressed or another external
trigger signal is generated, this trigger has no effect.
When Burst is selected, the following items will be displayed in the side menu:
Polarity
Level
Impedance
Burst Count
STOP
The Slope, Level and Impedance items are used to set the trigger conditions for
the external trigger signal.
Figure 3 -164 shows the output waveform for an external trigger signal.
Burst Mode