Filter
Top Products
Appendix C: Performance Verification
CĆ4
AWG2021 User Manual
The AWG2021 includes internal calibration routines that check electrical
characteristics such as amplitude, offset, trigger level, clock, filters, X5 output
amplifier and attenuation, and adjust internal calibration constants as necessary.
Equipment Required
None
Prerequisites Power on the AWG2021 and allow a 20 minute warmup period
before doing this procedure.
1. Verify that internal adjustments pass: Do the following substeps to verify
passing of internal adjustments.
a. Display the calibrations menu and select all tests: Push
UTILITY!Diag/Cal!Calibrations xxxx!All. See the menu in
Figure C-2.
Figure CĆ2: Calibrations Menu
b. Run the calibrations routine: Select Execute from the side menu. This
executes the AWG2021 calibrations routine automatically.
c. Wait: The internal calibration does an exhaustive verification of proper
AWG2021 function. While it progresses, the busy icon appears on
screen. When finished, the resulting status will appear on the screen.
d. Confirm that no failures are found: Verify that no failures are found and
reported on-screen. If the calibration displays Fail as the result, contact
our nearest representative.
2. Return to regular service: Push any button (other than UTILITY) in the
MENU column to exit the diagnostic menu.
Calibration