Filter
Top Products
Operating Examples
2 Ć48
AWG2021 User Manual
You will now add a noise waveform to the sine waveform.
1. Select New Waveform from the side menu in the initial EDIT menu.
2. Select Standard Waveform from the bottom menu.
3. Select Amplitude from the side menu.
4. Press “1” and ENTER in that order.
5. Check to make sure that the parameters for other items in the side menu are
set to the values shown below. If they are different, change them to the
values shown below.
Type Sine
Cycle 1.0
Offset 0.0000
6. Select Execute from the side menu.
The sine wave shown in Figure 2 -35 will be created.
Figure 2 Ć35: Creating a Sine Wave
7. Select Type from the side menu.
Creating Waveforms
Arithmetically