Filter
Top Products
Operating Examples
AWG2021 User Manual
2 Ć63
Figure 2 Ć52: MODE Menu
2. Select Cont from the bottom menu.
This operation mode continuously outputs the set waveform. Also, “Run-
ning” is displayed in the trigger status area on the upper right section of the
screen to show that the set waveform is being output.
3. Press the front panel CH1 On/Off button to enable waveform output.
When the output is on, the On/Off indicator lights up. This operation outputs
the specified waveform from the CH1 output connector. Set the oscilloscope
appropriately to display the waveform on the oscilloscope screen.
You can use the marker output from the instrument as the external trigger for
the oscilloscope. The marker signal is set in high state at data point 0. See
Figure 2 -53. The marker signal can be set to any point using the waveform
edit function.