Filter
Top Products
EDIT Menu
3 Ć14
AWG2021 User Manual
Waveform Editor
Use the waveform editor to create or edit waveform files with the extension of
.WFM. Waveform files contain waveform data, marker signal data, and the
waveform output parameters set with the SETUP menu. The waveform data
display formats are graphic, table, and timing. The editing functions displayed
depend on the data display format.
In the waveform editor, 0 to 4094 in 12-bit resolution on the vertical axis is
expressed as –1.0000 to +1.0000 (with 4095 as 1.0005). At this level, there is no
relationship to the Amplitude/Offset setting in the SETUP menu used when the
waveform is output.
1. Press EDIT in the MENU column. The initial EDIT menu will appear.
2. Select Edit or New Waveform from the side menu.
Edit Use this command to select and edit an existing
waveform file (.WFM)
New Waveform Use this command to create a new waveform file
As a result of the procedure described above, the waveform editor will
appear on the screen. The waveform editor can be displayed in one of three
formats: graphic, timing or table; the default setting is graphic display.
Figure 3 -7 shows an example in which an existing waveform file has been
selected.
Entering the Waveform
Editor