Filter
Top Products
EDIT Menu
3 Ć124
AWG2021 User Manual
Use Insert Other Waveform to insert data from another waveform at a
designated point in the waveform being edited. This item is located on the third
page(More 3 of 3) of the side menu. The functions of this item are the same as
for the Insert Other Waveform item for the graphic display of the waveform
editor. See Page 3 -60.
Use Shift Register Generator... to set a pseudo-random pulse pattern using a
shift register for the data between the designated vertical bar cursors on a data
line or marker. The following diagram shows the menu configuration for the
Shift Register Generator... item.
Operation ( More 3 of 3 )
Shift Register
Generator...
Line
Go Back
Execute
Register
Config...
Clear All Taps
Cancel
O.K.
Set Maximal
Set All Regs
Linear Taps
User defined
Code Config...
Initial Src
Initial Code
Out [I/O]
High/Low
Invert/Keep
0
0
1
1
Register Configuration. The pseudo-random pulse generator (with shift register)
consists of 2 to 32 registers together with the register output for each and the tap
of the feedback loop that performs the EX-OR operation. Selecting Register
Config... from the sub-menu enables you to set the pattern for the shift register
generator. Figure 3 -89 shows the menu used to set the shift register.
Figure 3 Ć89: Shift Register Configuration Menu
Inserting Other Waveform
Data
PseudoĆRandom Pulse
Generator