Filter
Top Products
EDIT Menu
3 Ć106
AWG2021 User Manual
Use Set Pattern to designate pattern data for the part of a data line or marker
between the designated vertical bar cursors. Figure 3 -81 shows the pattern data
menu that appears when you select Set Pattern from the sub-menu.
Figure 3 Ć81: Pattern Data Setting Menu
When the designated pattern is shorter than the area between the vertical bar
cursors, the pattern data is repeated. You can create a variety of bit strings for the
same pattern data by selecting Code in the menu.
Press the CURSOR button on the front panel to select the items needed for
setting the pattern data. The following items can be selected; use the general
purpose knob to set the desired value.
Cursor Position (sets the position of the cursor)
Point/Step (sets the number of points per step)
Code (used to select the data code)
Entering Pattern Data and Pattern Length. To enter the pattern data, press the
CURSOR button on the front panel and select Cursor Position. A knob icon
will appear to the left of the Cursor Position area. The value next to “Cursor
Position” in the menu indicates the current position of the cursor.
Now you can use the numeric keys to enter the pattern data. Any value up to
32,768 bits can be entered for pattern data. However, only 40 bits can be
displayed on the screen at one time; use the general purpose knob to scroll
Setting Pattern Data